Out with the old.
To start with ill be doing as much as i can at home on the jetty so when i do finally slip it ill save some time on the hard stand. I crawled into the fly bridge and disconnected all the wires from the back of the gauges. I stripped the gauges out and all the wiring down to the motors. Disconnected fuel lines, exhaust and shaft couplings. All this was done carefully as i am selling the old motors on eBay. This wasn't a very hard job and only took a couple of hours. By the way i have no downstairs steering station. While i was going i stripped out any wiring that wasn't needed, hot water system, plumbing and an old inverter i found underneath the steps.
No comments:
Post a Comment